With this tutorial, you can make a 4-In-1 Reversible Toddler Bucket Hat for non-commital types like me (I should clarify that I’m happily married, the non-commital part is just for everything else in my life) :). The pattern is sized 2T/3T, or approximate head circumference of 19″. I’m planning on making pattern pieces for larger and smaller head sizes in the near future, and I’ll be sure to let you know when I add them to the tutorial!
Okay, let’s get to work on our 4-In-1 Bucket Hat…
1/4 yd main fabric
1/4 yd co-ordinating fabric for reverse side of hat
optional: 1/2 yd fusible interfacing if your fabric is lightweight or you want extra stiffness in your hat (1/4 yd needed if interfacing only one side of hat)
Heat n Bond scraps
Pattern pieces – ensure that your printer is not set to scale the document larger or smaller before you print :).
1. Cut out fabrics and interfacing (optional) as marked on pattern pieces. When cutting interfacing, cut pieces 1/2″ smaller on all sides of pattern pieces.
3. Prepare your appliques. Apply Heat n Bond to wrong side of fabric (I used a scrap piece of knit for the applique on the printed side of the hat so I could applique with a straight stitch and leave the edges raw) and trace your design (remember to trace it backward if your applique is not symetrical!). Cut out design and iron to right side of one hat band piece on main fabric. You can center the design or place it off center if you’d rather. Stitch around design close to edge.
5. Clip top of hat band every 3/4″. Make sure that your cuts are less than 1/2″ long.
6. Right sides together, pin top edge of band to main fabric crown piece, matching raw edges. To mark the crown piece into quarters before pinning, I like to “finger press” it by folding it in half and then in half again and giving it a good pinch. It saves time and my home-ec teacher in high school even taught me it so it’s totally legit :).